VST OneTrack Especificações descarregar pdf (Página 64)

100

101

- 64 -

● As described in the “Track columns and the Inspector” chapter in the Getting

Started book, the Prg ﬁeld in the Inspector will show a GM Program name in-

stead of a number, if GM, GS or XG Mode are activated in the GM/GS/XG Editor.

Resetting Program Change

If you for example Copy and Paste or duplicate Parts a lot, Program Change mes-

sages setup in the Inspector might get copied or moved too, ending up in positions

where you don’t want them. The quickest way to get around this might be to start

over from scratch:

1. Make sure no Part is selected.

2. Select the Track for which you want to “reset” Program Change.

3. Use the Inspector to set the Program Change to “Off”.

Even if the box already says “Off”, adjust the value up and then down again to

make sure all Parts are set to “Off”.

4. Now select each Part for which you want a Program Change message,

and enter it in the Inspector.

Later in the Song, this Part sends out

Program Change 52 to make the

device switch to another Program.

Make sure that the Inspector says

“Trackinfo” at the top. Then, if you set

Program Change to Off, this setting is

“copied” to all Parts on the Track

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 494 495

Comentários a estes Manuais

Sem comentários

VST OneTrack Especificações Página 64

Comentários a estes Manuais