VST OneTrack Especificações descarregar pdf (Página 246)

100

101

- 246 -

Changing the End Inset

This is done just as changing the Start Inset, only you click or drag in the “lower

right corner” of the waveform. Changing the End Inset adjusts the Length of the

Event; that is, it hides more or less of the end of the ﬁle.

The End Inset can also be set numerically on the Info Line.

Changing the Insets with a single click

If you click somewhere along the very top edge of the segment (though not on the

segment name) the Start Inset will immediately be set to that position. Likewise,

clicking at the bottom edge of the segment moves the End Inset.

About Snap to Zero

If the option “Snap To Zero” in the Audio menu is enabled, all offset adjustment

will be followed by an automatic “search for a zero crossing”. This option will al-

ways make the resulting Segment very slightly smaller than it was when you re-

leased the mouse button. If there is absolute silence, and therefore no zero crossings

in the sample for some time, Cubase will ask whether it should continue the search.

For more info on Zero Crossings, see page 234.

● Group Events do not Snap to Zero.

The length of the section played back can be set using the Speaker pop-up as de-

scribed on page 242.

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 494 495

Comentários a estes Manuais

Sem comentários

VST OneTrack Especificações Página 246

Comentários a estes Manuais