VST OneTrack Especificações descarregar pdf (Página 317)

100

101

- 317 -

The Group Mixer

The Group Mixer is a separate mixer, with eight Groups (stereo channel pairs). You

can route several audio channels to the same Group, to mix them with a single set

of controls and add the same EQ or effects to all of them. This section describes the

Group Mixer and how to use it.

Routing an Audio Channel to a Group

1. Open the Monitor Mixer.

2. Locate the audio channel you want to route, and pull down the pop-up

menu at the bottom of its channel strip.

On the pop-up menu, the Groups are listed after the available Output Buses.

In this case, only one Output Bus is available (Master).

3. Select one of the eight Groups.

The output of the audio channel is now redirected to the selected Group.

● The Groups are in stereo, which means that the pan setting for the audio

channel is taken into account when you route the channel to a Group. If you

want to route a stereo channel pair to a Group, you should pan the channels

hard left/right and assign them to the same Group.

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 494 495

Comentários a estes Manuais

Sem comentários

VST OneTrack Especificações Página 317

Comentários a estes Manuais