VST OneTrack Especificações descarregar pdf (Página 467)

100

101

- 467 -

Song Start

This is the position on the time code tape that will make Cubase VST start the song

from the beginning. If you for example set this to 0:5:0:0:0 (ﬁve minutes) Cubase

VST will start from the beginning of the Song when it receives a time code message

with this value.

In other words, if Cubase VST receives a time code message of “seven minutes”

with the Song Start value suggested above, it will jump to a position two minutes in

from the beginning of the Song.

This way sequenced material can be matched to ﬁlm or video, and you can adjust

the relative starting points between e.g. material recorded on an audio tape and Cu-

base VST.

The Song Start value is in the following format:

hours:minutes:seconds:frames:subframes (80 bits).

Time Display Offset

The Time Position display on the Transport bar usually starts at “zero”, even if the

incoming time code is something else. But if you want Song Position 1.1.0 to cor-

respond to some certain Time position on the Transport bar, set this value with

Time Display.

If you for instance want the Transport bar to show the actual incoming time code

values during external synchronization, the “Song Start” and “Time Display”

should be set to the same value.

The Song Start time

code position.

This value will be used

for the time position of

the beginning of the

song.

1 2 ... 462 463 464 465 466 467 468 469 470 471 472 ... 494 495

Comentários a estes Manuais

Sem comentários

VST OneTrack Especificações Página 467

Comentários a estes Manuais